Kia Optima: Inspection
| 1. | Turn ignition switch OFF. |
| 2. | Disconnect the oil temperature sensor connector. |
| 3. | Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. | Check that the resistance is within the specification. |
Removal
1.
Remove the battery and the battery
tray. (Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
Tightening torque:7.8 ~
11 ...
See also:
Installation
1.
Install the brake pedal assembly
in dash panel.
2.
Pre-tighten the bracket fixing
bolt(B) in dash panel.
3.
Install the brake boost ...
Steering Angle Sensor. Description and Operation
Description
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering)
and it sends messages to HECU through CAN communication line.The SAS is used
to determine turning di ...
Components and Components Location
1. Piston ring
2. Snap ring
3. Piston
4. Connecting rod
5. Connecting rod upper bearing
6. Piston pin
7. Connecting rod lower bearing
8. Connecting ...
Copyright © www.kiopman.com 2024