1. Press the CRUISE ON-OFF button on the steering wheel to turn the system on. The CRUISE indicator light in the instrument cluster will illuminate.
2. Accelerate to the desired speed, which must be more than 40 km/h (25 mph).
3. Move the lever (1) down (to SET-), and release it at the desired speed. The SET indicator light in the instrument cluster will illuminate. Release the accelerator at the same time. The desired speed will automatically be maintained.
On a steep grade, the vehicle may slow down or speed up slightly while going downhill.
Repair procedures
Removal
Back View Camera
1.
Disconnect the negative(-) battery terminal.
2.
Open the trunk and remove the trunk door trim.
(Refer to the BD group - "Trunk")
3.
Disconnect the back view c ...
Accelerator Position Sensor (APS) Schematic Diagrams
Circuit Diagram
...
Underdrive Brake Control Solenoid Valve(UD/B_VFS). Description and Operation
Description
Underdrive brake control solenoid valve(UD/B_VFS) is attached to the valve body.
This variable force solenoid valve directly controls the hydraulic pressure inside
the underdrive brak ...