Inspection
First Seat Heater1. | Check for continuity and measure
the resistance between No.4 and No.6 terminals. [Cushion]
[Back]
|
2. | Operate the seat heater after
connecting the connector, and then check the thermostat by measuring the
temperature of seat surface.
|
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature
sensor connector.
3.
Measure resistance between sensor
signal terminal and sensor g ...
3 Point Rear Center Belt
To fasten the rear center belt
1. Slowly pull the tongue plates out from the retractor.
2. Insert the tongue plate (A) into the open end of the buckle (C) until an audible
“click" is heard, ...
Placing a Passenger Safety Belt Into The Auto Lock Mode
The use of the auto lock mode will ensure that the normal movement of the child
in the vehicle does not cause the safety belt to be pulled out and loosen the firmness
of its hold on the child re ...