Inspection
1. | Disconnect the negative (-) battery terminal. |
2. | Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") |
3. | Remove the crash pad side switch
assembly (A) as shown below picture.
|
4. | Disconnect the rheostat connector
(A) from lower crash pad switch.
|
5. | Operate the rheostat switch and
check for continuity between terminals.
|
ETC (Electronic Throttle Control) System. Specifications
Specification
[Throttle Position Sensor (TPS)]
Throttle Angle(°)
Output Voltage(V)
TPS1
TPS2
0
0.0
5.0
...
Installation
Sensor Fit
•
Handle the sensor with
care.
•
Avoid lubricant contact.
...
Installation
•
Install the component with the specified
torques.
•
Note that internal damag ...