Kia Optima: Replacement - A/C Pressure Transducer. Repair procedures - Air Conditioning System - Heating,Ventilation, Air Conditioning - Kia Optima TF 2011-2019 Service ManualKia Optima: Replacement

1. Disconnect the negative (-) battery terminal.
2. Recover the refrigerant with a recovery/charging station.
3. Disconnect the A/C pressure transducer connector (3P) (A).

Tightening torque :

10~12N.m (1.0~1.2kgf.m, 7.4~8.8lbf.ft)


Take care that liquid & suction pipe are not bent.
4. Installation is the reverse order of removal.

Inspection
1. Measure the pressure of high pressure line by measuring voltage output between NO.1 and NO.2 terminals. 2. Inspect the voltage value whether it is sufficie ...

Evaporator Temperature Sensor. Description and Operation
Description The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator freezing by excessive cooling ...

See also:

Removal
1. Disconnect the negative(-) battery terminal. 2. Remove the lens trunk trim. (Refer to the BD group - "Trunk") 3. Replace the bulb (A) ...

Front Seat. Repair procedures
Replaccement Seat Assembly Replacement 1. Remove the seat track mounting cover. 2. After loosening the seat assembly mounting bolts, remove the seat assembly (A). ...

Anti-Lock Brake System (ABS) Warning Light
This light illuminates when you start the engine. The light will go off if the ABS is operating normally. Also, this light comes on if the key is turned to ON, and then goes off in 2-3 seconds i ...

Copyright © www.kiopman.com 2019