Kia Optima: Repair procedures - Keyless Entry And Burglar Alarm - Body Electrical SystemKia Optima: Repair procedures

Inspection
Front Door Lock Actuator Inspection
1.
Remove the front door trim.
(Refer to the BD group - "Front door")
2.
Remove the front door module.
3.
Disconnect the 7P connector from the actuator.


4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.


Rear Door Lock Actuator Inspection
1.
Remove the rear door trim.
(Refer to the BD group - "Rear door")
2.
Remove the rear door module.
3.
Disconnect the 7P connector from the actuator.


4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.


Trunk Lid Release Actuator Inspection
1.
Remove the trunk lid trim panel.
(Refer to the BD group - "Trunk lid")
2.
Disconnect the 3P connector from the actuator.


3.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.


Front Door Lock Switch Inspection
1.
Remove the front door trim panel.
(Refer to the BD group - "Front door")
2.
Remove the front door module.
3.
Disconnect the 7P connector from the actuator.


4.
Check for continuity between the terminals in each switch position when inserting the key into the door according to the table.


Rear Door Lock Switch Inspection
1.
Remove the rear door trim panel.
(Refer to the BD group - "Rear door")
2.
Remove the rear door module.
3.
Disconnect the 7P connector from the actuator.


4.
Check for continuity between the terminals in each switch position according to the table.


Trunk Lid Open Switch Inspection
1.
Remove the trunk lid trim.
(Refer to the BD group - "Trunk lid")
2.
Disconnect the connector from the actuator.


3.
Check for continuity between the terminals in each switch position according to the table.


Door Switch Inspection
Remove the door switch and check for continuity between the terminals.

Hood Switch Inspection

Hood Switch Inspection


Hood Switch Inspection
1.
Disconnect the connector from the hood switch (A).


2.
Check for continuity between the terminals and ground according to the table.


Burglar Horn Inspection
1.
Remove the burglar horn (A) after removing 1 bolt and disconnect the connector from the burglar horn.


2.
Test the burglar horn by connecting battery power to the terminal 1 and ground the terminal 2.
3.
The burglar horn should make a sound. If the burglar horn fails to make a sound replace it.
Description and Operation
Description Burglar Alarm State [B/A State] B/A StateDescriptionDISARM 1) In "DISARM" state, no vehicle start inhibition. So, when door, hood, or Tailgate is opened, there is no alarm sound ...

Transmitter Repair procedures
Inspection 1. Check that the red light flickers when the door lock or unlock button is pressed on the transmitter. 2. Remove the battery (A) and check voltage if the red light doesn''t flicker ...

See also:

Installation
1. Install the heater control unit. 2. Install the center fascia panel. 3. Install the crash pad garnish. ...

Automatic Transaxle Operation
The optional automatic transaxle is electronically controlled. All normal forward driving is done with the shift lever in the D (Drive) position. To move the shift lever from the P (Park) position ...

Body Control Module (BCM) Components and Components Location
Components Connector Pin Information No.Connector A (24pin)Connector B (20pin)Connector C (24pin)1Battery (+)Head lamp low beam switchRoom lamp2IGN 1Head lamp high beam switchAV tail signal3IGN ...

Copyright © www.kiopman.com 2020