When shift shock is occurred or parts related with the
transaxle are replaced, TCM learning should be performed. In the
following case, TCM learning is required.
•
Transaxle assembly replacement
•
TCM replacement
•
Valve body replacement
•
TCM upgrading
TCM learning procedure
1.
TCM learning condition
–
ATF temperature: 40 ~ 95°C (104 ~ 203°F)
2.
TCM learning procedure
a. Stop learning
–
Repeat the below shift pattern four times or more with stepping on the brake.
Driving learning
1) Drive the vehicle through all gears at D range. Drive from
stop to 1st to 2nd to 3rd to 4th to 5th to 6th with keeping fixed
throttle open.
2) Down shift from 6th to 5th, 5th to 4th, 4th to 3rd, 3rd to 2nd, 2nd to 1st.
3) Repeat the above driving pattern four times or more.
Description
Automatic transaxle system relies on various measurement data
to determine the current control status and extrapolate the necessary
compensation values. These values are used to con ...
Headlight escort function
The headlights (and/or taillights) will remain on for approximately 20 minutes
after the ignition key is removed or turned to the ACC or LOCK position. However,
if the driver’s door is opened and ...
Fuse Inspection
1.
Be sure there is no play in the
fuse holders, and that the fuses are held securely.
2.
Are the fuse capacities for each
circuit correct?
3.
Are the ...