Kia Optima: Removal - Turn Signal Lamp. Repair procedures - Lighting System - Body Electrical System - Kia Optima TF 2011-2021 Service ManualKia Optima: Removal

Side Repeater Lamp

1. Disconnect the negative (-) battery terminal.
2. Open the front door.
3. Remove the side repeater lamp assembly by using the a flat-tip screwdriver.

Apply the protective tapes on the arrow area and its related parts.
4. Replace the bulb if it is necessary.
Door Mirror Turn Signal Lamp
1. Disconnect the negative (-) battery terminal.
2. Remove the door mirror and door mirror cover (A) after removing the screw.

Take care not to damage the mirror holder fixing clip.
3. Remove the door mirror cover (A) after removing the fixing clip.

Take care not to damage the mirror cover fixing clip.
4. Remove the door mirror turn signal lamp (B) after removing the screw and connector (A).


Turn Signal Lamp. Repair procedures
...

Installation
Side Repeater Lamp 1. Install the bulb to the side repeater lamp assembly. 2. Install the side repeater lamp. Door Mirror Turn Signal Lamp 1. Install the do ...

See also:

Fan speed control
The ignition switch must be in the ON position for fan operation. The fan speed control knob allows you to control the fan speed of the air flowing from the ventilation system. To change the fan ...

Intake Air Temperature Sensor (IATS). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the IATS connector. 3. Measure resistance between the IATS terminals 3 and 4. ...

Troubleshooting
Trouble Shooting Ignition System SymptomSuspect areaRemedyVehicle indicates Ready in dash, but engine will not run when requested by the HPCU (HEV module).Ignition coilInspect ignition coil, or ...

Copyright © www.kiopman.com 2021