Kia Optima: Removal
| 1. | Disconnect the negative (-) battery terminal. |
| 2. | Remove the driver airbag module. (Refer to the RT group) |
| 3. | Remove the steering wheel. (Refer to the ST group - "Steering column & shaft") |
| 4. | Remove the steering wheel cover
(A) after loosening the screws.
|
| 5. | Remove the steering wheel remote
control switch connector (A) after loosening the mounting screws.
|
![[LH-Audio]](images/books/1609/stfbe1043d.gif)
![[LH-Mute]](images/books/1609/stfbe1044d.gif)
Inspection
1.
Check the audio remote control
switch (A) for resistance between connector terminals in each switch position.
[LH-Audio]
[LH-Mute]
[Audio]
Switch
...
Installation
1.
Reassemble the steering wheel
remote control switch after connecting the connector.
2.
Reassemble the steering wheel.
3.
Reassemble the driver airbag
...
See also:
High Voltage Shut-off Procedures
High Voltage Shut-off Procedures
Be sure to read and follow the “General Safety Information
and Caution” before doing any work related with the high voltage
sys ...
ECM Terminal And Input/Output signal
ECM Terminal Function
Connector [CHTG-AG]
Pin
No.
Description
Connected to
1
Ignition Coil (Cylinder #2) control output [W ...
Overdrive Clutch Control Solenoid Valve (OD/C_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Remove the air duct (A).
Tightening torque:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
3.
Remove the air cleaner assembly.
(1)
D ...