Kia Optima: Removal - Line Pressure Control Solenoid Vale. Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Kia Optima TF 2011-2026 Service ManualKia Optima: Removal

Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraulic pressure will need to be adjusted after replacing the VFS solenoid valve. If replacing the VFS solenoid valve; also replace the valve body assembly. (Refer to "Valve Body" in this group)

Inspection
1. Turn ignition switch OFF. 2. Disconnect the oil temperature sensor connector. 3. Measure resistance between sensor signal terminal and sensor g ...

35R Clutch Control Solenoid Valve(35R/C_VFS). Description and Operation
Description 35R clutch control solenoid valve(35R/C_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 35R clutch. ...

See also:

Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher than the bottom of the wheel hub. Drive through any water slowly. Allow adequate stopping distance because brake perf ...

Installation
• Install the component with the specified torques. • Note that internal d ...

3 Point Rear Center Belt
To fasten the rear center belt 1. Slowly pull the tongue plates out from the retractor. 2. Insert the tongue plate (A) into the open end of the buckle (C) until an audible “click" is hear ...

Copyright www.kiopman.com 2026