Kia Optima: Removal
1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable. |
3. |
Disconnect the CVVT oil control valve connector (B). |
4. |
Remove the installation bolt (C), and then remove
the valve from the engine. 
|
1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable. |
2. |
Disconnect the CVVT oil control valve connector (A). |
3. |
Remove the installation bolt (B), and then remove
the valve from the engine. 
|
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV terminals 1 and
2.
4.
...
•
Install the component with the specified
torques.
•
Note that internal damag ...
See also:
Installation
1.
Install the rear combination
lamp (Inside) assembly.
2.
Install the rear combination
lamp (outside) assembly.
...
Removal
1.
If the compressor is marginally
operable, run the engine at idle speed, and let the air conditioning work
for a few minutes, then shut the engine off.
2.
Disconnec ...
Engine Oil. Repair procedures
...