Kia Optima: Output Speed Sensor Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemKia Optima: Output Speed Sensor Repair procedures

Inspection
1.
Check signal waveform of Input & output speed sensor using the GDS.

Specification: Refer to "Signal Wave Form" section.

Removal
   
   
Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries.
Be sure to shut off the high voltage circuit according to the “High Voltage Shut-off Procedures” before doing any work related with the high voltage system to avoid serious electrical injuries.
1.
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
2.
Disconnect the input & output speed sensor connector (A).
3.
Remove the input & output speed sensor (B) after removing the bolts.

Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Installation


Installation
1.
Install in the reverse order of removal.
   
   
Do not reuse the drain plug gasket and the valve body cover gasket, oil cooler tube washer.
Perform the procedures below after installing
1)
Refill the automatic transaxle with fluid.
(Refer to Hydraulic System - "Fluid")
2)
Refill the engine & transaxle cooling system with coolant.
(Refer to Engine Mechanical System - "Coolant")
3)
Refill the hybrid motor cooling system with coolant and then perform the air bleeding using the GDS.
(Refer to Hybrid Motor System - "Coolant")
4)
Reset the automatic transaxle adaptive values using the GDS.
5)
Confirm the coolant leak or fluid leak from the hose connections part in state of engine start.
Output Speed Sensor Troubleshooting
Signal Waveform ...

Engine Clutch Control Solenoid Valve (E/C_VFS) Description and Operation
Description Engine clutch control solenoid valve (E/C_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure to the engine clutch. ...

See also:

Child seat anchorage position
For small children and babies, the use of a child seat or infant seat is strongly recommended. This child seat or infant seat should be of appropriate size for the child and should be installed in ...

Power Out Side Mirror Switch Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim panel. (Refer to the BD group - "Front door") 3. Disconnect the connector and remove the door mir ...

Automatic Transaxle. Components and Components Location
Components Location 1. Converter housing 2. Automatic transaxle case 3. Rear cover 4. Valve body cover 5. Manual control lever 6. Air breather hose 7. Inhib ...

Copyright www.kiopman.com 2021