Kia Optima: Oil And Filter Replacement - Engine Oil. Repair procedures - Lubrication System - Engine Mechanical System - Kia Optima TF 2011-2020 Service ManualKia Optima: Oil And Filter Replacement

Х Prolonged and repeated contact with mineral oil will result in the removal of natural fats from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.
Х Exercise caution in order to minimize the length and frequency of contact of your skin to used oil. Wear protective clothing and gloves. Wash your skin thoroughly with soap and water, or use water-less hand cleaner, to remove any used engine oil. Do not use gasoline, thinners, or solvents.
Х In order to preserve the environment, used oil and used oil filter must be disposed of only at designated disposal sites.
1. Park the car on level ground.

Start the engine and let it warm up.

2. Drain engine oil.
(1) Remove the oil filler cap.
(2) After lifting the car, remove the oil drain plug (A) and drain oil into a container.
3. Replace the oil filter (B).
(1) Remove the oil filter.
(2) Check and clean the oil filter installation surface.
(3) Check the part number of the new oil filter is as same as old one.
(4) Apply clean engine oil to the gasket of a new oil filter.
(5) Lightly screw the oil filter into place, and tighten it until the gasket contacts the seat.
(6) Tighten it with the torque below.

Tightening torque :

11.8 ~ 15.7N.m (1.2 ~ 1.6kgf.m, 8.7 ~ 11.6lb-ft)


4. Install the oil drain plug with a new gasket.

Tightening torque :

34.3 ~ 44.1N.m (3.5 ~ 4.5kgf.m, 25.3 ~ 32.5lb-ft)


5. Fill with new engine oil, after removing the engine oil level gauge.

Capacity :

Total : 5.5 L (1.45 U.S.gal., 5.81 U.S.qt., 4.84 lmp.qt.)

Oil pan : 4.2 L (1.11 U.S.gal., 4.44 U.S.qt., 3.70 lmp.qt.)

Drain and refill including oil filter :

4.6 L (1.22 U.S.gal., 4.86 U.S.qt., 4.05 lmp.qt.)
6. Install the oil filler cap.
7. Start engine and check for oil leaks and check the oil gauge or light for an indication of oil pressure.
8. Recheck the engine oil level.

Engine Oil. Repair procedures
...

Inspection
1. Check the engine oil quality. Check the oil deterioration, entry of water, discoloring of thinning. If the quality is visibly poor, replace the oil. 2. Check t ...

See also:

SRS Control Module (SRSCM). Description and Operation
Description The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to discriminate between an event that warrants restraint system deployment and an event that does n ...

Withheld alarm
When the alarm is armed, the alarm will not sound if the trunk lid is opened with either the key or the transmitter. However, if the trunk lid is not opened completely within two seconds after unlo ...

Components and Components Location
Components 1. Steering wheel 2. Steering column 3. ECU 4. Motor 5. Steering gear box MDPS Circuit Diagram Harness Connector ...

Copyright © www.kiopman.com 2020