Kia Optima: Measurement Point - General Information - Kia Optima TF 2011-2018 Service ManualKia Optima: Measurement Point

Measurements should be taken at the center of the hole.

Checking Cables And Wires

Measuring Actual Dimensions
1. These dimensions indicate the actual linear distance between measurement points, and are used as the reference dimensions when a tracking gauge is used for measurement. ...

Checking Cables And Wires
1. Check the terminal for tightness. 2. Check terminals and wires for corrosion from battery electrolyte, etc. 3. Check terminals and wire ...

See also:

Installation
1. Install the rear combination lamp (Inside) assembly. 2. Install the rear combination lamp (outside) assembly. ...

Intake Manifold. Components and Components Location
Components   1. Intake manifold assembly 2. Electronic throttle body 3. Intake manifold stay 4. Intake manifold gasket ...

Inspection
1. Measure terminal-to-terminal resistance of the blower resistor. 2. measured resistance is not within specification, the blower resistor must be replaced. (After re ...

Copyright © www.kiopman.com 2018