Kia Optima: Line Pressure Control Solenoid Vale Schematic Diagrams - Automatic Transaxle Control System - Automatic Transaxle SystemKia Optima: Line Pressure Control Solenoid Vale Schematic Diagrams

Circuit Diagram


Line Pressure Control Solenoid Vale Specifications
Specifications Direct control VFS[LINE Pressure] Control type : Normal high type Control Pressure kpa(kgf/cm?, psi)500.14 ~ 9.81(5.1 ~ 0.1, 72.54 ~ 1.42)Current value (mA)50 ~ 850 Intern ...

Line Pressure Control Solenoid Vale Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct (A). Tightening torque: 7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft) 3. Remove the air cleaner assembly. (1) D ...

See also:

ETC (Electronic Throttle Control) System Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Throttle ...

Compass Mirror Repair procedures
Calibration Procedure If the compass has been calibrated or set to variance zone number incorrectly, or you are driving in specific places (tunnel, parking lot in building, underground parking ...

Troubleshooting
Engine Overheat Troubleshooting Inspection RemedyVisual inspectionInspect for shortage of coolant in reservoir tank .Reinspect after replenishing coolant.Inspect for coolant pollution after remo ...

Copyright © www.kiopman.com 2020