Kia Optima: Inspection - Rear Hub - Carrier. Repair procedures - Rear Axle Assembly - Driveshaft and axle - Kia Optima TF 2011-2019 Service ManualKia Optima: Inspection

1. Check the hub for cracks and the splines for wear.
2. Check the brake disc for scoring and damage.
3. Check the rear axle carrier for cracks.
4. Check the bearing for cracks or damage.

Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove wheel nuts, rear wheel and tire from rear hub. Ti ...

Suspension System
...

See also:

To resume cruising speed at more than approximately 40 km/h (25 mph)
If any method other than the cruise ON/OFF switch was used to cancel cruising speed and the system is still activated, the most recent set speed will automatically resume when the RES+ switch is ...

Removal
In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by ...

Anti-Lock Brake System (ABS) Warning Light
This light illuminates when you start the engine. The light will go off if the ABS is operating normally. Also, this light comes on if the key is turned to ON, and then goes off in 2-3 seconds i ...

Copyright © www.kiopman.com 2019