Kia Optima: Inspection
| 1. | Turn ignition switch OFF. |
| 2. | Disconnect the oil temperature sensor connector. |
| 3. | Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. | Check that the resistance is within the specification. |
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional
hydraulic pressure adjustment; however, the hydraulic pre ...
See also:
Knock Sensor (KS) Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Drain the engine coolant (Refer to “Cooling System” in EM group).
3.
Remove the radiator u ...
Installation
1.
The key of crankshaft should
be aligned with the mating face of main bearing cap. As a result of this,
the piston of No.1 cylinder is placed at the top dead center on compression ...
Replacement
1.
Remove the front wheel & tire.
Tightening torque:88.3
~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1~79.6lb-ft)
...
Copyright www.kiopman.com 2021