Kia Optima: Inspection - Output Speed Sensor. Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Kia Optima TF 2011-2019 Service ManualKia Optima: Inspection

1. Check signal waveform of Input & output speed sensor using the GDS.

Specification: Refer to "Signal Wave Form" section.

Output Speed Sensor. Repair procedures
...

Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). Tightening torque:7.8 ~ 11 ...

See also:

Immobilizer Control Unit. Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") 3. ...

Reassembly
1. Wrap tape around the driveshaft spline(TJ) to prevent damage to the boots. 2. Apply grease to the joint boot on the side of the wheel and install the boot. ...

Inspection
1. Ignition "OFF" 2. Disconnect the connector of temperature control actuator. 3. Verify that the temperature control actuator operates to t ...

Copyright © www.kiopman.com 2019