Kia Optima: High Voltage Shut-off Procedures - Suspension SystemKia Optima: High Voltage Shut-off Procedures

High Voltage Shut-off Procedures
   
   
Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries.
   
   
High voltage components: High Voltage Battery Pack Assembly, Power Relay Assembly (PRA), BMS ECU, Hybrid Power Control Unit (HPCU), Hybrid Drive Motor, HSG, Electric A/C Compressor, Low DC/DC Converter (LDC), Power Cable, Electric Compressor etc.
1.
Turn the ignition switch OFF and disconnect the auxiliary 12V battery negative (-) terminal.
2.
Remove the safety plug.
(1)
Remove the safety plug cover (A).


(2)
Unfasten the hook (A) and then remove the safety plug (C) by pulling the lever (B) to the direction of arrow.


3.
Wait for more than 5 minutes so that the capacitor in the high voltage system can be fully discharged.
4.
Measure the voltage between the inverter terminals to check that the capacitor in the inverter is discharged completely
(1)
Remove air cleaner assembly and air duct.(Refer to Engine Mechanical System – “Air Cleaner”)
(2)
Disconnect the inverter power cable (A).


   
   
Disconnect the inverter power cable as the procedures below.


(3)
Measure the voltage between the inverter (+) terminal and the inverter (-) terminal.

Less than 30V : High voltage circuit properly shut
More than 30V : Faulty on high voltage circuit


   
   
If measured more than 30V, check if the safety plug is removed completely.If measured more than 30V despite the safety plug is removed, it can be serious problems on the high voltage circuit. In this case, check DTC and never touch on the high voltage system.
General Safety Information and Caution
Safety Precaution     Since hybrid vehicles contain a high voltage battery, if the high voltage system or vehicles are handled incorrectly, this might lead to a ser ...

Specifications
Specifications Front Suspension ItemSpecificationSuspension typeMacPherson StrutShock absorberTypeHPD (High Performance Damper)Coil springFree Height [I.D. color]299.5mm (11.79 in.) [White - Yel ...

See also:

Tips on Driving Your Vehicle
Before Entering Vehicle: Be sure that all windows, outside mirror(s), and outside lights are clean. Check the condition of the tires. Check under the vehicle for any sign of leaks. Be sure t ...

Speed sensing door lock system (if equipped)
All doors will be automatically locked after the vehicle speed exceeds 15 km/h (9.3 mi/h). And all doors will be automatically unlocked when you turn the engine off or when you remove the ignition ...

Components
1. Duct Seal 2. Duct Case 3. Inlet Door 4. Intake Actuator 5. Inlet Duct Case (A) 6. Climate Control Air Filter 7. Cluster Ionizer 8. Climate Control Air Fi ...

Copyright www.kiopman.com 2020