Kia Optima: Front Stabilizer Bar. Repair procedures

Inspection

1. Check the bushing for wear and deterioration. 2. Check the front stabilizer bar for deformation. 3. Check the all bolts and nuts. ...

Replacement

1. Remove the front wheel & tire. Tightening torque:88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1~79.6lb-ft) ...

See also:

Removal
1. Remove the timing chain. (Refer to Timing system in this group) 2. Install a stopper pin (A) after compressing the balance shaft chain tensioner. 3. ...

Mode Control Actuator. Description and Operation
Description The mode control actuator is located at the heater unit.It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select s ...

Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driver side crash pad to ...