Removal |
1. |
Lift the vehicle. |
2. |
Disconnect the fuel filler hose (A). |
3. |
Disconnect the ventilation hose (B) from the fuel tank air filter. |
4. |
Open the fuel filler door and then remove the filler-neck installation screw (A). |
5. |
Remove the rear-LH wheel, tire, and the inner wheel house. |
6. |
Remove the filler-neck assembly from the vehicle after removing the bracket installation bolt (A). |
Installation |
1. |
Install in the reverse order of removal.
|
Operating door locks from outside the vehicle
Turn the key toward the rear of the vehicle to unlock and toward the front
of the vehicle to lock.
If you lock/unlock the door with a key, all vehicle doors will lock/unlock
automatically ...
Front Driveshaft Repair procedures
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove wheel nuts, front wheel and tire from front hub.
Tightening torque:
88. ...
Description
Network ConfigurationThe Network of the SJB(Smart Junction Box) consists of Low
speed CAN as shown in the following figure.
Termination ResistorThe cluster has CAN termination resistor. It is p ...