Kia Optima: Engine Clutch Control Solenoid Valve (E/C_VFS) Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemKia Optima: Engine Clutch Control Solenoid Valve (E/C_VFS) Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Remove the air duct (A).

Tightening torque:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)


3.
Remove the air cleaner assembly.
(1)
Disconnect the breather hose (A).
(2)
Disconnect the air intake hose (B) and then remove the air cleaner assembly (C).

Tightening torque:
Hose clamp bolt:
2.9 ~ 4.9 N.m (0.3 ~ 0.5 kgf.m, 2.2 ~ 3.6 lb-ft)
Air cleaner assembly bolts:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)


   
   
When installing the air intake hose, the plate of the hose clamp must be in line with the stopper of the hose.
When installing the air intake hose, the center of the mark of hose must be in line with the throttle body rib.


4.
Remove the solenoid valve connector (A).


5.
Measure resistance between signal terminal and ground terminal.
6.
Check that the resistance is within the specification.
Removal
   
   
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraulic pressure will need to be adjusted after replacing the VFS solenoid valve. If replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
Engine Clutch Control Solenoid Valve (E/C_VFS) Schematic Diagrams
Circuit Diagram ...

26 Brake Control Solenoid Valve(26/B_VFS) Description and Operation
Description 26 brake control solenoid valve(26/B_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure to the 26 brake. ...

See also:

Pressure Source Unit Components and Components Location
Components     PSU must not be disassembled. 1. Motor connecter2. Bracket3. Block4. Accumulator5. Damper6. Motor ...

SRS Control Module (SRSCM). Description and Operation
Description The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to discriminate between an event that warrants restraint system deployment and an event that does n ...

Catalytic Converter. Description and Operation
Description The catalytic converter of the gasoline engine is a three way catalyst. It oxidizes carbon monoxide and hydrocarbons (HC), and separates oxygen from the oxides of nitrogen (NOx). ...

Copyright www.kiopman.com 2020