Kia Optima: Delivery Pipe Repair procedures - Fuel Delivery System - Engine Control/Fuel SystemKia Optima: Delivery Pipe Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group).
3.
Disconnect the injector connector (A).
4.
Remove the wiring harness bracket mounting bolt (B).
5.
Remove the mounting nut, and then disconnect the fuel feed tube (C).
6.
Remove the mounting bolt (D), and then remove the delivery pipe & injector assembly from the engine.

Installation

Installation


Installation
1.
Install in the reverse order of removal.

Delivery pipe mounting bolt:
18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)
Delivery pipe mounting nut (- Fuel feed tube):
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)7

Accelerator Pedal Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the mounting nuts (B) and ...

Automatic Transaxle System
...

See also:

Mode Control Actuator. Description and Operation
Description The mode control actuator is located at the heater unit.It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select s ...

Rear Combination Light Bulb Replacement
1. Using a cross-tip screwdriver, remove the cover. 2. Turn the bulb socket counterclock-wise and remove it from the housing. 3. Push the bulb in, then rotate it one quarter turn counterclockwise ...

One-Touch Wipers
For a single wiping cycle, push the lever forward and release it with the lever in the OFF position. The wipers will operate continuously if the lever is pushed forward and held. ✽ NOTICE ...

Copyright www.kiopman.com 2021