Kia Optima: Closing the Hood
- Check the area under the hood to make certain all filler caps are in place and that all loose items have been removed.
- Lower the hood then push down to properly lock in place.
- Check to make sure the hood is closed.
WARNING
- Before closing the hood, make sure that all engine parts and tools have been removed from the engine area and that no one’s hands are near the hood opening.
- Do not leave gloves, rags or any other combustible material in the engine compartment. Doing so may cause a heat-induced fire.
Opening the Hood
1. Pull the release lever on the lower left side of the instrument panel to unlatch
the hood.
2. Go to the front of the vehicle, slightly raise the hood, pull up on the secondary
latch and li ...
Fuel Filler Lid
...
See also:
Yaw-rate and Lateral G Sensor. Repair procedures
Removal
1.
Turn ignition switch OFF and
disconnect the negative (-) battery cable.
2.
Remove the floor console. (Refer
to the Body group - Console)
3.
...
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove wheel nuts, front wheel
and tire from front hub.
...
Tire terminology and definitions
Air Pressure: The amount of air
inside the tire pressing outward on
the tire. Air pressure is expressed in
pounds per square inch (psi) or kilopascal
(kPa).
Accessory Weight: This means the
...
Copyright © www.kiopman.com 2024