1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait a few minutes for the oil to return to the oil pan.
4. Pull the dipstick out, wipe it clean, and reinsert it fully.
5. Pull the dipstick out again and check the level. The level should be between
F and L.
If the level is near or at L, add enough oil to bring the level to F. Do not overfill.
Use only the specified engine oil. (Refer to “Recommended Lubricants’’ later in this section.)
Installation
1.
Reconnect the auto light connector.
2.
Install the auto light sensor.
...
Power Seat Motor Repair procedures
Inspection
Power Seat Motor
1.
Disconnect the connectors for each motor.
A : Front height motor
B : Slide motor
C : Rear height motor
D : Recline motor
E : Lumber support motor
2.
With ...
Line Pressure Control Solenoid Vale. Specifications
Specifications
Direct control VFS[LINE Pressure]▷ Control type : Normal low type
Control Pressure kpa(kgf/cm², psi)
500.14~9.81(5.1~0.1,72.54~1.42)
...