Kia Optima Manuals

Kia Optima: Adjustment - Brake Pedal. Repair procedures - Brake System - Brake System - Kia Optima TF 2011-2026 Service ManualKia Optima: Adjustment

Stop lamp switch clearance adjustment
If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0mm(0.04~ 0.08in), conform to below.
1. Disconnect the stop lamp switch connector (B).
2. Release locking plate by pushing the hooks (B) carefully, and then pull the locking plate (A) as indicated by the arrow (C).
3. Turn stop lamp switch 45° counterclockwise and remove it.
4. Fix the brake pedal arm and insert fully the stop lamp switch as hiding contact part.
5. After inserting, turn the stop switch (A) 45° clockwise, and then assemble locking plate (B) by pushing.
6. Confirm the gap between stop lamp switch and bracket.
Stop lamp clearance:

1.0 ~ 2.0 mm (0.04 ~ 0.08 in.)

7. Connect the stop lamp switch connector.

Inspection
1. Check the bushing for wear. 2. Check the brake pedal for bending or twisting. 3. Check the brake pedal return spring for damage. 4. ...

Installation
1. Install the brake pedal assembly in dash panel. 2. Pre-tighten the bracket fixing bolt(B) in dash panel. 3. Install the brake boost ...

See also:

Recommended cold tire inflation pressures
All tire pressures (including the spare) should be checked when the tires are cold. “Cold Tires” means the vehicle has not been driven for at least three hours or driven less than 1.6 km ...

Windshield defrosting and defogging
WARNING - Windshield heating Do not use the or position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and the windshield could ...

Sports Mode
Whether the vehicle is stationary or in motion, sports mode is selected by pushing the shift lever from the “D” position into the manual gate. To return to “D” range operation, push the ...

Categories

Kia Optima Manuals

Copyright www.kiopman.com 2026