Troubleshooting
1. | The lamp switch inputs can be checked using the GDS. |
2. | To check the input value of lamp switch, select option "Body Control Module". |
3. | To consult the present input/output
value of BCM, "Current DATA". It provides information of BCM input/output
conditions of power supply, turn signal/brake lamp, headlamp, door, locks,
outside mirror, wiper, auto-light and transmitters etc.
|
4. | To check the input value of lamp
switch in force mode, select option "Actuation Test".
|
Symptom |
Possible cause |
Remedy |
One lamp does not light (all exterior) |
Bulb burned out |
Replace bulb |
Socket, wiring or ground faulty |
Repair if necessary |
|
Stop lamps do not light |
Bulb burned out |
Replace bulb |
Stop lamp fuse (15A) blown |
Check for short and replace fuse |
|
Stop lamp switch faulty |
Adjust or replace switch |
|
Wiring or ground faulty |
Repair if necessary |
|
Stop lamps do not turn off |
Stop lamp switch faulty |
Repair or replace switch |
Instrument lamps do not light (Tail lamps light) |
Rheostat faulty |
Check rheostat |
Wiring or ground faulty |
Repair if necessary |
|
Back up lamps do not light |
Bulb burned out |
Replace bulb |
Back up lamp fuse (10A) blown |
Check for short and replace fuse |
|
Back up lamp switch (M/T) faulty |
Check switch |
|
Transaxle range switch (A/T) faulty |
Check switch |
|
Wiring or ground faulty |
Repair if necessary |
|
Map lamp does not light |
Bulb burned out |
Replace bulb |
Room lamp fuse (10A) blown |
Check for short and replace fuse |
|
Map lamp switch faulty |
Check switch |
|
Wiring or ground faulty |
Repair if necessary |
|
Luggage room lamp does not light |
Bulb burned out |
Replace bulb |
Trunk lamp fuse (10A) blown |
Check for short and replace fuse |
|
Luggage room lamp switch faulty |
Check switch |
|
Wiring or ground faulty |
Repair if necessary |
Necessary Inspections
Fluid levels, such as engine oil, engine coolant, brake/clutch fluid, and washer
fluid should be checked on a regular basis, with the exact interval depending on
the fluid. Further details are pro ...
Special
Service Tools
Special Service Tools
Tool (Number and name)
Illustration
Use
Alternator pulley remover wrench
(09373-27000)
Removal ...
Recommended SAE Viscosity Number
✽ NOTICE
Always be sure to clean the area around any filler plug, drain plug, or dipstick
before checking or draining any lubricant. This is especially important in dusty
or sandy areas an ...