1. | Connect the DLC cable of GDS
to the data link connector (16 pins) in driver side crash pad lower panel,
turn the power on GDS.
|
2. | Select the vehicle model and
then do "CODE SAVING"
|
3. | After selecting "CODE SAVING"
menu, button "ENTER" key, then the screen will be shown as below.
|
4. | After removing the ignition key
from key cylinder, push "ENTER" key to proceed to the next mode for code
saving. Follow steps 1 to 4 and then code saving is completed.
|
Identification Number Description. Vehicle Identification Number
1.
World Manufacturer Identifier
(WMI)- KNA (Korea) : Passenger vehicle, MPV(Multipurpose
Passenger Vehicle)/SUV(Sports Utility Vehicle)/RV(Recreational Vehicle)
- 5XX (U. ...
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of
TPS 1 and 2 at C.T. and ...
Engine temperature gauge
This gauge shows the temperature of the engine coolant when the ignition switch
is ON.
Do not continue driving with an overheated engine. If your vehicle overheats,
refer to “If the engine over ...