Kia Optima: Starter. Repair procedures

[VALEO]

1. Front bracket 2. Stop ring 3. Stopper 4. Overrun clutch assembly 5. Internal gear assembly 6. Lever 7. Lever stop 8. Magnet switch assembly 9. Driv ...

Removal and Installation

1. Remove the engine cover. 2. Disconnect the battery negative terminal (A). Tightening torque :4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft) ...

See also:

Installation
1. Installation is the reverse of removal. 2. Tighten the HECU mounting bolts and nuts to the specified torque. 3. After installation, bleed the b ...

Manual Antenna
Your car uses a manual stainless steel antenna to receive both AM and FM broadcast signals. Pull up the antenna using your fingers, as shown in the drawing. ✽ NOTICE Before entering an au ...

Dimensions Projected
1. These are the dimensions measured when the measurement points are projected from the vehicle's surface, and are the reference dimensions used for used for body alterations ...