Kia Optima: Seat Belt Buckle Switch (BS). Description and Operation
Description
The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status input. The seat belt buckle circuit operates from internal boost voltage supplied by the SRSCM, and uses chassis ground for the signal return. The buckle status shall modify the SRSCM deployment. If the buckle status is unbuckled, the corresponding pretensioner will not be deactivated.
Installation
Pressure Side Impact Sensor
1.
Install the new pressure side
impact sensor with the screws then connect the pressure side impact sensor
connector.
Tightening t ...
See also:
Checking the engine oil level
2.4 engine
2.0 engine
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach
normal operating temperature.
3. Turn the engine off and wait for a few
min ...
Changing the Engine Oil and Filter
Change engine oil and filter according to the Scheduled Maintenance at the beginning
of this section.
WARNING - Engine Oil
Continuous contact with USED engine oil has caused skin cancer in la ...
Closing the trunk
To close, lower the trunk lid, then press down on it until it locks. To be sure
the trunk lid is securely fastened, always check by trying to pull it up again.
WARNING
The trunk lid should be alw ...
Copyright © www.kiopman.com 2024