Kia Optima: Resetting The Panoramaroof
Whenever the vehicle battery is disconnected or discharged, or you use the emergency
handle to operate the panoramaroof, you have to reset your panoramaroof system as
follows :
| 1. |
Turn the ignition key to the
ON position and then close the panoramaroof completely. |
| 2. |
Release the panoramaroof control
lever. |
| 3. |
Press and hold the CLOSE button
for more than 10 seconds until the panoramaroof has moved slightly. |
| 4. |
Release the panoramaroof control
lever. |
| 5. |
Press and hold the CLOSE button
once again within 3 seconds until the panoramaroof do as follows;
| A. |
Tilt → Slide Open → Slide
Close Then release the lever.
|
|
| 6. |
Reset procedure of panorama system
is finished. |
Protecting Motor From Overheating
In order to protect the panoramaroof motor from
overheating from continuous motor operation, the panoramaroof ECU controls the Run-time
and Cool-time of the motor as follows:
| 1. |
The panoramaroof ECU detects
the Run- time of motor |
| 2. |
Motor can be operated continuously
for the 1st run-time(120 ± 10sec.). |
| 3. |
The continuous operation of motor
stops after the 1st Run-time(120 ± 10sec.). |
| 4. |
Then Motor is not operated for
the 1st Cool-time(18 ± 2sec.). |
| 5. |
Motor is operated for the 2nd
Run-time(10 ± 2sec.) at the continued motor operation after 1st Cool-time(18
± 2sec.) |
| 6. |
The continuous operation of motor
stops operating after the 2nd Run-time(10 ± 2sec.) |
| 7. |
Motor is not operated for the
2nd Cool-time(18 ± 2sec.). |
| 8. |
Motor repeats the 2nd run-time
and 2nd cool-time at the continued motor operation.
| A. |
In case that motor is
not operated continuously, the run-time is increased. |
| B. |
The Run-Time of motor
is initialized to "0" if the battery or fuse is reconnected after
being disconnected, discharged or blown. |
T1 : 120 ± 10 sec., T2 : 18 ± 2 sec.,T3 : 10 ± 2 sec., T4 : 18 ± 2 sec.
|
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the roof trim.(Refer
to the BD group - "Roof trim")
3.
Disconnect the panoram ...
See also:
Smart key
With a smart key, you can lock or unlock a door and even start the engine without
inserting the key.
The functions of the buttons on a smart key are similar to the remote keyless
entry. (Refer ...
Inspection
Armature Inspection
And Test
1.
Remove the starter.
2.
Disassemble the starter as shown at the beginning
of this procedure.
...
Installation
1.
Install the front fog bulb.
2.
Reconnect the lamp connector.
3.
Install the front bumper.
...
Inspection
Lighting System