To program a device to HomeLink using a HomeLink button previously trained, follow these steps:
1. Press and hold the desired HomeLink button. Do not release until step 4 has been completed.
2. When the indicator light begins to flash slowly (after 20 seconds), hold the handheld transmitter 1 to 3 inches away from the bottom of the mirror.
3. Press and hold the transmitter button (or, if necessary, press and "cycle," as described in the ‘"Gate Operator & Canadian Programming" portion of this text).
4. The HomeLink indicator light will flash slowly at first, then rapidly, indicating successful programming. Release both buttons.
Tire Replacement
If the tire is worn evenly, a tread wear indicator will appear as a solid band
1/2 inch wide (12.7 mm) across the the tread. This shows there is less than 1/16
inch (1.6 mm) of tread left on the t ...
Installation
1.
Remove the ignition key from
the vehicle.
2.
Disconnect the battery negative
cable from battery and wait for at least three minutes before beginning
work.
...
ESC OFF Switch. Repair procedures
Inspection
1.
Turn ignition switch OFF and
disconnect the negative (-) battery cable.
2.
Remove the crash pad side switch
assembly.
3.
Check ...