1. | Disconnect the negative (-) battery terminal. |
2. | Remove the crash pad. (Refer to BD group - "Crash Pad") |
3. | Disconnect the Intake actuator connector (A) |
4. | Loosen the mounting screw and
then remove the intake actuator (B).
|
5. | Installation is the reverse order of removal. |
Power Steering
Checking the Power Steering Fluid Level
With the vehicle on level ground, check the fluid level in the power steering
reservoir periodically. The fluid level should be between MAX and MIN indicat ...
Air Bag Warning Light
The purpose of the air bag warning light in your instrument panel is to alert
you of a potential problem with your Air Bag - Supplemental Restraint System (SRS).
Have the system checked if:
The ...
Lumbar support
The lumbar support can be adjusted by pressing the lumbar support switch on the
side of the drivers seat. Press the front portion of the switch to increase support,
or the rear portion of the sw ...