1. | Disconnect the negative (-) battery terminal. |
2. | Using the screwdriver, remove
the side cover (A).
|
3. | Loosen the mounting screws and
then remove the crash pad lower cover (A)
|
4. | Disconnect the connector (A),
and then remove the crash pad lower cover.
|
5. | Remove the shower duct (A).
|
6. | Loosen the mounting bolts and
then remove the BCM. (Refer to BE group - “BCM”) |
7. | Disconnect the temperature control actuator connector (A) |
8. | Loosen the mounting screw and
then remove the temperature control actuator (B).
|
9. | Using the screw driver, remove
the side cover (A).
|
10. | Remove the main crash pad lower
cover (A).
|
11. | Disconnect the damper (B) and
glove box lift (C) from the glove box (A).
|
12. | Disconnect the pin (A) and then
remove the glove box (B).
|
13. | Loosen the mounting screw and
bolts and than remove the glove box housing (A).
|
14. | Remove the shower duct (A).
|
15. | . Disconnect the temperature control actuator connector (A). |
16. | Loosen the mounting screw and
then remove the temperature control actuator (B).
|
17. | Installation is the reverse order of removal. |
Adjustment
Stop lamp switch clearance adjustment
If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0mm(0.04~ 0.08in),
conform to below.
1.
Disconnect the stop lamp switch
...
TPMS Receiver. Description and Operation
Operation
1.
General Function
A.
Spare tire inflation
/ DTC state is not displayed.
2.
General Conditions to Learn New
Sensors :
...
Installation
•
Install the component with the specified
torques.
•
Note that internal damag ...