1. | Disconnect the negative (-) battery terminal. |
2. | Remove the crash pad. (Refer to BD group - “Crash Pad”) |
3. | Loosen the screws and then remove
the cluster ionizer (A).
|
4. | Installation is the reverse order of removal. |
Output Speed Sensor. Troubleshooting
Signal Waveform
Fig 1) Input/Output speed sensor at low speedFig 2) Input/Output speed sensor
at high speed
...
Replacement
Head Lamp (Low)
[General type]
1.
Turn the head lamp switch off.
2.
Disconnect the power connector
from the lamp.
3.
Remove the head lamp (Low ...
Special Service Tools
Special Service Tools
Tool (Number and Name)
Illustration
Use
09546-26000
Strut spring compressor
Compression of coil s ...