1. | Disconnect the negative (-) battery terminal. |
2. | Loosen the mounting screw and
then remove the crash pad lower cover (A).
|
3. | Remove the evaporator temperature
sensor (A), by pulling it after rotating 90° in a counterclockwise direction.
|
4. | Installation is the reverse order of removal. |
Installation
1.
Install the power window switch
module.
2.
Install the door trim panel after
reconnecting the relevant connectors
...
Starter
Relay. Repair procedures
Inspection
1.
Remove the fuse box cover.
2.
Remove the starter relay (A).
3.
Using an ohmmeter, check that there is continuit ...