Kia Optima: Replacement
| 1. |
Recover the refrigerant with
a recovery/ recycling/ charging station. |
| 2. |
Disconnect the negative (-) battery
terminal. |
| 3. |
Remove the discharge line and
liquid line (A) from the condenser.
Tightening torque :
3.9~5.8 N.m(0.4~0.6Kgf.m, 2.9~4.3 Ib-ft)
|
|
Plug or cap the lines immediately after disconnecting them to avoid
moisture and dust contamination. |
|
| 4. |
Disconnect the mounting clip,
and then remove the air duct hose assembly (A).
|
| 5. |
Loosen the radiator bracket mounting
bolts (A).
|
| 6. |
Remove the radiator fan. (Refer
to EM group - “Radiator”)
|
| 7. |
Disconnect the pin (A) and then
remove the condenser (C) from radiator (B).
|
| 8. |
Install in the reverse order
of removal, and note these items :
| A. |
If you're installing
a new condenser, add refrigerant oil ND-OIL8. |
| B. |
Replace the O-rings with
new ones at each fitting, and apply a thin coat of refrigerant oil
before installing them. Be sure to use the right O-rings for R-134a
to avoid leakage. |
| C. |
Be careful not to damage
the radiator and condenser fins when installing the condenser. |
| D. |
Be sure to install the
lower mount cushions of condenser securely into the holes. |
| E. |
Charge the system, and
test its performance. |
|
1.
Check the condenser fins for
clogging and damage. If clogged, clean them with water, and blow them with
compressed air. If bent, gently bend them using a screwdriver or pliers.
...
Replacement
1.
Remove the condenser, and then
remove the bottom cap (B) with L wrench (A) from the condenser.
Tightening torque :20~25N.m
(2.0~2.5kgf.m, 14.5~18.2lb-ft) ...
See also:
Service Standard
Item
Specification
Ignition Timing (°)
BTDC 6 ± 10
Idle Speed (rpm)
A/C OFF
Neutral, N, P-range
70 ...
Removal
1.
Disconnect the negative(-) battery
terminal.
2.
Remove the heater comtral module.
(Refer to the HA group - "Controller")
...
Disarmed stage
The alarm will be deactivated when:
The “” button on the transmitter
is pressed.
The ignition switch is in the “ON” position for 30 seconds or more.
Unlock or lock the doors with the transm ...
Inspection
Receiver-Drier. Repair procedures