Kia Optima: Replacement
| 1. | Turn ignition switch OFF. |
| 2. | Disconnect the negative (-) battery cable. |
| 3. | Disconnect the TCM connector
(A).
|
| 4. | Remove the TCM (C) after removing
the mounting bolts (A) and nut (B).
|
Inspection
TCM Problem Inspection Procedure
1.
TEST TCM GROUND CIRCUIT: Measure
resistance between TCM and chassis ground using the backside of TCM harness
connector as TCM side check point. If ...
Installation
1.
Installation is reverse of removal.
In the case of the vehicle equipped with immobilizer or but ...
See also:
Electric WGT Control Actuator. Specifications
Specification
[EWGA Position Sensor]
Position
Output Voltage[V]
Operating Angle[°]
Range of Rod [mm], reference
Mechanical Close end ...
Intake Manifold. Components and Components Location
Components
1. Intake manifold assembly
2. Electronic throttle body
3. Intake manifold stay
4. Intake manifold gasket
...
Intake Manifold. Repair procedures
Removal and Installation
1.
Remove the engine cover.
2.
Disconnect the battery negative
terminal (A).
Tightening torque4.0 ~
6.0N.m (0.4 ~ 0.6kgf.m, 3. ...
Copyright © www.kiopman.com 2024