Inspection
Front Door Lock Actuator Inspection1. | Remove the front door trim. (Refer to the BD group - "Front door") |
2. | Remove the front door module. |
3. | Disconnect the 7P connector from
the actuator.
|
4. | Check actuator operation by connecting
power and ground according to the table. To prevent damage to the actuator,
apply battery voltage only momentarily.
|
1. | Remove the rear door trim. (Refer to the BD group - "Rear door") |
2. | Remove the rear door module. |
3. | Disconnect the 7P connector from
the actuator.
|
4. | Check actuator operation by connecting
power and ground according to the table. To prevent damage to the actuator,
apply battery voltage only momentarily.
|
1. | Remove the trunk lid trim panel. (Refer to the BD group - "Trunk lid") |
2. | Disconnect the 3P connector from
the actuator.
|
3. | Check actuator operation by connecting
power and ground according to the table. To prevent damage to the actuator,
apply battery voltage only momentarily.
|
1. | Remove the front door trim panel. (Refer to the BD group - "Front door") |
2. | Remove the front door module. |
3. | Disconnect the 7P connector from
the actuator.
|
4. | Check for continuity between
the terminals in each switch position when inserting the key into the door
according to the table.
|
1. | Remove the rear door trim panel. (Refer to the BD group - "Rear door") |
2. | Remove the rear door module. |
3. | Disconnect the 7P connector from
the actuator.
|
4. | Check for continuity between
the terminals in each switch position according to the table.
|
1. | Remove the trunk lid trim. (Refer to the BD group - "Trunk lid") |
2. | Disconnect the 3P connector from
the actuator.
|
3. | Check for continuity between
the terminals in each switch position according to the table.
|
Remove the door switch and check for continuity between the terminals.
Hood Switch Inspection
1. | Disconnect the connector from
the hood switch (A).
|
2. | Check for continuity between
the terminals and ground according to the table.
|
1. | Remove the burglar horn (A) after
removing 1 bolt and disconnect the 2P connector from the burglar horn.
|
2. | Test the burglar horn by connecting battery power to the terminal 1 and ground the terminal 2. |
3. | The burglar horn should make a sound. If the burglar horn fails to make a sound replace it. |
Engine Oil Pressure Warning
This warning light indicates
the engine oil pressure is low.
If the warning light comes on while driving:
1. Drive safely to the side of the road and stop.
2. With the engine off, check the engin ...
Restraint of Pregnant Women
Pregnant women should wear lap/shoulder belt assemblies whenever possible according
to specific recommendations by their doctors. The lap portion of the belt should
be worn AS SNUGLY AND AS LOW AS ...
Checking the washer fluid level
Check the fluid level in the washer fluid
reservoir and add fluid if necessary. Plain
water may be used if washer fluid is not
available. However, use washer solvent
with antifreeze charac ...