Kia Optima: Removal and Installation
1. |
Disconnect the battery negative terminal.
Tightening torque
:4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
|
|
2. |
Remove the driver airbag module. (Refer to the RT
group - "Airbag module")
|
3. |
Remove the steering wheel. (Refer to the ST group
- "Steering column and shaft") |
4. |
Remove the steering wheel cover (A) after loosening
the screws.
|
5. |
Disconnect the cruise control switch connector (A)
and then remove the switch.
Be careful not to damage the hook when removing
the switch. |
|
6. |
Installation is the reverse of removal. |
Measuring Resistance
1.
Disconnect the cruise control switch connector from
the control switch.
2.
Measure resistance between terminals on the con ...
See also:
Description
Automatic transaxle system relies on various measurement data to determine the current
control status and extrapolate the necessary compensation values. These values are
used to control the actuat ...
Troubleshooting
Troubleshooting
Symptom
Possible cause
Remedy
Hard steering
Improper front wheel alignment
Excessive turning resistance of lower arm ba ...
If the engine stalls at a crossroad
or crossing
If the engine stalls at a crossroad or
crossing, set the shift lever in the N
(Neutral) position and then push the vehicle
to a safe place. ...