Kia Optima: Removal and Installation
1. |
Disconnect the battery negative terminal first, then
the positive terminal.
Tightening torque
:(+) terminal : 7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m,
5.8 ~ 7.2lb-ft)
(-) terminal : 4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m,
3.0 ~ 4.4lb-ft)
|
|
2. |
Disconnect the A/C compressor switch connector (A)
the alternator connector (B), and the cable from alternator "B" terminal
(C).
|
3. |
Remove the drive belt (A) after turning the drive
belt tensioner (B) counterclockwise.
|
4. |
Pull out the through bolt and then remove the alternator
(A).
Tightening torque
:49.0 ~ 63.7N.m (5.0 ~ 6.5kgf.m, 36.2 ~ 47.0lb-ft)
|
|
5. |
Installation is the reverse order of removal. |
1.
Remove the alternator cover (A) using a screw driver
after loosening the nuts (B).
2.
Remove the slip ring guide (A) and then loosen the
...
See also:
Aux, USB and iPod®* port
If your vehicle has an aux and/or USB(universal serial bus) port or iPod® port,
you can use an aux port to connect audio devices and an USB port to plug in an USB
and also an iPod® port to plug ...
Inspection
1.
Check-points upon head lamp failure
(HID)
(1)
Check the battery voltage.
(Low beam will be on when the battery voltage above 9V.)
(2)
...
Lumbar support
The lumbar support can be adjusted by pressing the lumbar support switch on the
side of the drivers seat. Press the front portion of the switch to increase support,
or the rear portion of the sw ...