Kia Optima: Removal and Installation
1. |
Loosen the drain plug, and then
drain the engine coolant. Remove the radiator cap to drain with speed. |
2. |
Remove the drive belt (A) after
turning the drive belt tensioner (B) counterclockwise.
|
3. |
Remove the water pump pulley
(A).
Tightening torque :7.8
~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8~ 7.2lb-ft)
|
|
4. |
Remove the water pump sub assembly
(A) with the gasket.
Tightening torque :9.8
~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
|
|
5. |
Remove the exhaust manifold heat
protectors (A).
Tightening torque :7.8
~ 11.8N.m (0.8 ~ 1.2kgf.m, 5.8 ~ 8.7lb-ft)
|
|
6. |
Remove the water pump cover (A)
with the gasket and the water inlet pipe (B).
Tightening torque :18.6
~ 23.5N.m (1.9 ~ 2.4kgf.m, 13.7 ~ 17.4lb-ft)
|
Tightening torque :9.8
~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
|
|
7. |
Installation is reverse order
of removal with a new water pump gasket. |
8. |
Fill the engine coolant. |
9. |
Start the engine and check for
leaks. |
10. |
Recheck the coolant level. |
1.
Check each part for cracks, damage
or wear, and replace the coolant pump assembly if necessary.
2.
Check the bearing for damage,
abnormal noise and sluggish rotat ...
See also:
TPMS Receiver. Description and Operation
Operation
1.
General Function
A.
Spare tire inflation
/ DTC state is not displayed.
2.
General Conditions to Learn New
Sensors :
...
Installation
•
Install the component with the specified
torques.
•
Note that internal damag ...
Interior General Precautions
Prevent caustic solutions such as perfume and cosmetic oil from contacting the
dashboard because they may cause damage or discoloration. If they do contact the
dashboard, wipe them off immediately ...