Kia Optima: Removal
1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable. |
2. |
Remove the intake manifold (Refer to “Intake And
Exhaust System” in EM group). |
3. |
Disconnect the knock sensor connector (A). |
4. |
Remove the installation bolt (B), and then remove
the sensor from the cylinder block.
|
•
Install the component with the specified
torques.
•
Note that internal damag ...
See also:
Installation
Pressure Side Impact Sensor
1.
Install the new pressure side
impact sensor with the screws then connect the pressure side impact sensor
connector.
Tightening t ...
Smart key. Repair procedures
Smart Key
Smart Key Code Saving
1.
Connect the DLC cable of GDS
to the data link connector in driver side crash pad lower panel, turn the
power on GDS.
2.
Sel ...
Line Pressure Control Solenoid Vale. Specifications
Specifications
Direct control VFS[LINE Pressure]▷ Control type : Normal low type
Control Pressure kpa(kgf/cm², psi)
500.14~9.81(5.1~0.1,72.54~1.42)
...