Kia Optima: Removal
1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable. |
2. |
Remove the resonator and the air intake hose (Refer
to “Intake And Exhaust System” in EM group). |
3. |
Disconnect the ETC module connector. |
4. |
Disconnect the coolant hoses (B). |
5. |
Remove the installation bolts (A), and then remove
the ETC module from the engine.
|
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of
TPS 1 and 2 at C.T. and ...
•
Install the component with the specified
torques.
•
Note that internal damag ...
See also:
Suspension System. Tires/Wheels. Wheel. Repair procedures
Hub nut tightening sequence
Tighten the hub nuts as follows.
Tightening torque:88.3 ~ 107.9N.m
(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Special Service Tools
Special Service Tools
Tool (Number and name)
Illustration
Use
09861-31100
Sealany cut-out tool
Cutting windshield seal ...
Mode Selection
Controls the direction of air flow through the ventilation system.
The air from outlet port flows at any mode. Close the ventilation outlets using
the knob to block the air flow if you do not wan ...