1. | Disconnect the negative (-) battery terminal. |
2. | Remove the driver crash pad lower
panel. (Refer to the BD group - "Crash pad") |
3. | Remove the steering column upper
and lower shrouds. (Refer to the BD group - "Crash pad") |
4. | Remove the wiper switch. (Refer to the BE group - "Multifunction switch") |
5. | Remove the ignition switch after
disconnecting the ignition switch 6P connector (A)
|
6. | Remove the key warning/immobilizer
connector (A).
|
7. | After loosening the screw, remove
the key warning switch and key Illumination (A).
|
8. | Pushing lock pin with key ACC.
|
9. | Remove the key lock cylinder
(A).
|
Installation
•
Install the component with the specified
torques.
•
Note that internal damag ...
Replacement
1.
Disconnect the battery negative
cable from the battery and then wait for at least 30 seconds.
2.
Turn the steering wheel so that
the front wheels can face straight ...
Intake Actuator. Description and Operation
Description
1.
The intake actuator is located
at the blower unit.
2.
It regulates the intake door
by signal from control unit.
3.
Pressing the intake ...