Parking Assist Sensor
1. | Disconnect the negative (-) battery terminal. |
2. | Remove the rear bumper. (Refer to the BD group - "Rear bumper") |
3. | Disconnect the connector (A)
connected to the rear bumper.
|
4. | Pull out the sensor (A) by opening
the sensor holder (B) out.
|
5. | Disconnect the sensor connector
(B) from the sensor (A) inside of the rear bumper.
|
1. | Disconnect the negative (-) battery terminal. |
2. | Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad") |
3. | Remove the steering column assembly. (Refer to the ST group - "Steering column and shaft") |
4. | Remove the BCM.
(Refer to the "Body control module") |
5. | Remove the buzzer (A) after loosening
the bolt and disconnecting the 2P connector.
|
1. | Disconnect the negative (-) battery terminal. |
2. | Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") |
3. | Remove the crash pad side switch
assembly (A) as shown below picture.
|
4. | Remove the RPAS switch (A) after
disconnecting the connector.
|
Installation
1.
Install the wiper motor.
2.
Install the crank arm.
Tighting torque:24.5 ~
26.4Nm (2.5 ~ 2.7, kgf.m, 18.0 ~ 19.5 lbf.ft)
...
Input Speed Sensor. Schematic Diagrams
Circuit Diagram
...
Special Service Tools
Special Service Tools
Tool(Number and Name)
Illustration
Use
09581-11000
Piston expander
Spreading the front and rear ...