Rear Combination lamp (Outside)
1. | Disconnect the negative (-) battery terminal. |
2. | Remove the rear combination lamp
cover (A).
|
3. | Replace the tail/stop lamp and
turn signal lamp bulbs (A) by turning it counterclockwise.
|
4. | Remove the mounting nuts (4EA).
|
5. | Remove the rear combination lamp
(A) after disconnecting the connector (B).
|
6. | Replace the tail/stop lamp and
turn signal lamp bulbs (A) by turning the sockets (B) counterclockwise.
|
1. | Disconnect the negative (-) battery terminal. |
2. | Remove the trunk trim. (Refer to the BD group - "Trunk") |
3. | If the tail lamp bulb should
be only replaced without removing lamp assembly, replace the tail lamp bulb
(A) after removing the trim cover in the trunk.
|
4. | Remove the rear lamp assembly
(A) after removing the nuts (3EA) and connector.
|
5. | Replace the tail lamp and back
up lamp bulbs (A) by turning the sockets (B) counterclockwise.
|
Seat
Driver’s seat
(1) Seat adjustment, forward / backward (2) Seatback recliner (3) Seat adjustment,
height (4) Lumbar support (5) Driver position memory system* (6) Seat warmer
switch* (7) Headres ...
Removal
-
Take care not to scratch
the crash pad and related parts
Smart key unit
1.
Disconnec ...
Air Bag Warning
This warning light will
remain on for approximately 6 seconds each time you turn the ignition switch ON.
If the system does not operate as described or if the light comes on while the vehicle
is ...