Room Lamp
1. | Disconnect the negative(-) battery terminal. |
2. | Carefully remove the lamp lens
(A) from the room lamp with a flat-tip screwdriver.
[B type]
|
3. | Replace the bulbs (A) and remove
the screws if it is necessary.
|
4. | Remove the room lamp assembly
(A) after disconnecting the connector (B).
|
1. | Disconnect the negative (-) battery terminal. |
2. | Remove the vanity lamp (A) by
pressing the clip (B) with a small screwdriver.
|
3. | Remove the vanity lamp assembly after disconnecting the connector. |
Rubber Parts And Tubes
Always prevent gasoline or from touching rubber parts or tubing.
...
Mode Control Actuator. Description and Operation
Description
The mode control actuator is located at the heater unit.It adjusts position of
mode door by operating mode control actuator based on signal of A/C control unit.
Pressing mode select s ...