|
1. | Remove the rain sensor cover
(A) first.
Be careful not to damage the cover latch by applying excessive force. To remove the latch, pull aside the latch using the cover hole (B) with the little (-) screwdriver (C).
|
2. | Remove the wiring harness connector (D) from sensor. |
3. | Rain sensor module is attached to the front windshield by glue replacing the front windshield, remove the rain sensor module from the existing front windshield and install on the new front windshield. |
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Remove the intake manifold (Refer to “Intake And
Exhaust System” in EM gro ...
Installation
•
Install the component with the specified
torques.
•
Note that internal damag ...
Schematic Diagrams
Circuit Diagram
...