|
1. | Disconnect the negative (-) battery terminal. |
2. | Remove the front bumper. (Refer to the BD group - "Front bumper") |
3. | Remove the washer hose and disconnect
the washer motor connector (A) and level sensor connector (B).
|
4. | Remove the washer motor (A).
|
5. | Remove the washer reservoir after
removing 2 bolts (A).
|
Thermostat. Repair procedures
...
Intake Air Temperature Sensor (IATS). Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and
4.
...
Tightening Torque Table Of Standard Parts
Bolt nominal diameter (mm)
Pitch (mm)
Torque Nm (kg.cm, lb.ft)
Head Mark 4
Head Mark 7
...